Thermal Bathing· Cold Plunge·

Tools

Sauna Heater Size Calculator: How Many kW Do You Need?

By the Carefree Retreat team

Updated 2026

Sauna heaters are sold in kilowatts, and the usual starting point is about 1 kW for every cubic metre of room. The catch is that a glass door, a tiled wall or solid log walls soak up heat, so a room can need a much bigger heater than its size suggests. Put in your room's measurements below and the calculator works out the adjusted volume heater makers ask you to size against, and the kW that goes with it.

Your sauna room

Inside measurements

Measure inside the cladding, floor to ceiling. For 200 cm, enter 2.

Heat-hungry surfaces

How the sum works

Start with the room's volume. Length times width times height gives the cubic metres of air the heater has to warm. Harvia, one of the largest sauna heater makers, works on an average of about 1 kW of heater power for each cubic metre, and most manufacturers print a minimum and maximum room size in cubic metres against every model.

Add an allowance for glass and masonry. Glass, stone, brick, tile and concrete draw heat out of the room far faster than an insulated timber wall. The standard allowance in heater manuals is to add 1.2 cubic metres to the room for every square metre of these surfaces. Harvia's own worked example is a 10 m³ room with a glass door, which needs the same output as a 12 m³ room.

Allow for solid log walls. Uninsulated log walls absorb a lot of heat before the room comes up to temperature, so heater manuals tell you to multiply the volume by 1.5. The calculator applies that factor to the room volume and then adds the glass and masonry allowance on top. The manuals do not say which order to use, so on a log room with lots of glass, check the result against your heater maker's own table.

Choosing the heater

  • Size against the adjusted volume, not the real one. Look up the room size range printed for each model and pick one whose range includes your adjusted figure. Models are sold in steps, so two neighbouring sizes often both cover it.
  • Too small is worse than slightly large. An undersized heater runs flat out, takes a long time to warm the room and may struggle to reach a proper sauna temperature on a cold day. If your adjusted volume sits right at the top of a model's range, the next size up gives you more margin.
  • Check the electrics before you buy. A 13 amp plug on a 230 volt supply tops out at about 3 kW, so most heaters above that are wired into their own circuit. Get an electrician to confirm what your supply and consumer unit can take before you settle on a size.
  • Infrared cabins work differently. This calculator is for traditional heaters with stones, electric or wood-fired. Infrared panels warm you directly rather than the air, and are sized by the cabin maker.

Once you know the heater size, the sauna running cost calculator turns its kW into a cost per session at your tariff, the sauna water loss calculator shows how much to drink afterwards, and the sauna and cold plunge planner builds you a session to use it for.

Found a place we’ve missed? Tell us about it.

Back to top

More from Carefree Retreat

The Quiet List

A slow letter, once a month.

One thoughtfully chosen UK retreat, a seasonal ritual to try at home, and where to find true quiet. No noise, ever.

Unsubscribe anytime. We never share your details.